AMX Distributed Audio Controllers Delta Series Spécifications télécharger pdf (Page 29)

Chapter 2 Installation and Wiring|VFD-B Series

2-12 Revision July 2008, BE16, SW V4.08 & V5.00

VFD-PU01

RUN

JOG

DATA

RESET

STOP

PROG

MODE

RUN

STOP

VFD- PU0 1

REVFWDJOG

2.4 Wiring

After removing the front cover, check if the power and control terminals are clear of debris. Be sure

to observe the following precautions when wiring.



General Wiring Information

Applicable Codes

All VFD-B series are Underwriters Laboratories, Inc. (UL) and Canadian Underwriters Laboratories

(cUL) listed, and therefore comply with the requirements of the National Electrical Code (NEC) and

the Canadian Electrical Code (CEC).

Installation intended to meet the UL and cUL requirements must follow the instructions provided in

“Wiring Notes” as a minimum standard. Follow all local codes that exceed UL and cUL

requirements. Refer to the technical data label affixed to the AC motor drive and the motor

nameplate for electrical data.

The "Line Fuse Specification" in Appendix B, lists the recommended fuse part number for each

VFD-B Series part number. These fuses (or equivalent) must be used on all installations where

compliance with U.L. standards is a required.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 238 239

Pas de commentaire

AMX Distributed Audio Controllers Delta Series Spécifications Page 29