AMX MAX-HT12T Manuel d'instructions télécharger pdf (Page 26)

MXT/D-1000 - 10.1" X Series Panels

MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels

The Backbox is clear to allow visual confirmation that the tabs have been extended and are gripping the wall,

as well as in assisting with removal if necessary.

For additional strength, #4 mounting screws (not included) may be secured through circular holes located at

the left and right sides of the MXD-1000 (FIG. 19). In order to prevent damage to the touch panel, make sure

that these are flush with the Backbox.

8. Insert each connector into its corresponding location along the back of the device.

To reach the RJ45 connector, gently pull it from beneath the electronics cover (FIG. 21).

Attach the Ethernet cable and gently push the connection back under the cover.

9. Test the incoming wiring by attaching the panel connections to their terminal locations and applying power.

Verify that the panel is receiving power and functioning properly to prevent repetition of the installation.

Remove power before continuing with the installation.

10. Latch the panel onto the hooks on the Backbox.

Push in on the bottom snaps (Landscape) or on the right (Portrait) (FIG. 22) gently but firmly until the snaps “click”

to lock it down.

FIG. 21 MXD-1000 - rear view

RJ45 cable clip

RJ45 Cable/Port

USB PortMicro-USB Port

Do not disconnect the connectors from the touch panel. The unit must be installed

with the attached connectors before being inserted into the mounting surface.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 61 62

Pas de commentaire

AMX MAX-HT12T Manuel d'instructions Page 26