AMX RPMLoader Manuel d'utilisateur télécharger pdf (Page 19)

Programming the NXB-CCG (for Clear Connect Dimmers and Switches)

RPM Device Configuration Guide - NXB-CCG NetLinx Clear Connect Gateway

Configuring Buttons 1-6: Adding Dimmer Functions

To configure the Lighting Control Buttons 1-6 on the touch panel (see FIG. 42 on page 13) to match RPM Lighting

Scenes 1-6:

1. In the Program page, click on Button 1 (under CCT Processor in the Devices window) to open the Button 1 Details

page (FIG. 45).

2. In the Button 1 Details page, click Add Device to open the Add Devices To Button popup (FIG. 46):

3. Select Dimmer to add a dim level setting to Button 1.

4. Click Add to add the Dimmer to Button 1. This action closes the popup and adds the Dimmer Programming table

to the Button 1 Details page (FIG. 47):

The Dimmer Programming table consists of four columns:

You can add both a Dimmer and a Switch to a button. In this case, both functions will

be activated when that button is pressed on the touch panel. For example, Button 1

can be configured to place the dimmer at 20% as well as turn the switch to Off.

FIG. 45 NXB-CCG WebConsole - CCT Processor: Button 1 Details page

FIG. 46 Add Devices To Button popup

FIG. 47 Button Details page - Dimmer Programming table

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 35 36

Pas de commentaire

AMX RPMLoader Manuel d'utilisateur Page 19