AMX AVB-WP-TX-MULTI-DXLINK Manuel d'instructions télécharger pdf (Page 52)

Installation and Setup

Instruction Manual – DXLink™ Twisted Pair Transmitters/Receiver

4. Ensure the ground wire is positioned so that it does not interfere with any of the connectors.

5. Attach the ground wire to a common earthed ground (see “Attaching a Ground Wire to a Common

Earthed Ground” on the previous page).

6. Continue the DXLink Module installation process (or reapply power to the module).

Attaching Ground Wire to Wallplate TX or Decor Wallplate TX

The Wallplate TX and Decor Wallplate TX each have a designated ground screw on the rear; look for the

grounding symbol. If the DXLink Wallplate does not have a designated screw, use the screw directly

above the DXLink (RJ-45) connector on the rear for grounding.

To attach a ground wire to a DXLink Wallplate or Decor Wallplate TX:

If powered, power down the unit by removing the DXLink cable from the rear.

2. Remove the ground screw and washer for the applicable unit, as indicated in FIG. 24.

3. Secure the ring terminal of the ground wire against the chassis with the ground screw and washer.

FIG. 23 Position ground wire away from connectors

FIG. 24 Wallplate TX and Decor Wallplate TX - Remove ground screw and washer

Correctly positioned ground wires

Designated ground screw

DXLink connector

1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 153 154

Pas de commentaire

AMX AVB-WP-TX-MULTI-DXLINK Manuel d'instructions Page 52