Amx Sensors and Receivers IR Manuel d'utilisateur télécharger pdf (Page 19)

Wiring and Installation

R Sensors and Receivers

Installation method B

Use when installing a swivel-mount unit using the provided mounting bracket.

On drywall, install using the included wall anchors. Use a 3/16-inch drill bit.

On wood, install using the included #6 mounting screws.

1. If you are installing the IRX-SM+, remove the housing and wire the unit to the AMX IR

receiver as shown in Wiring.

2. If you are installing the AXR-IRSM+, remove the housing and locate the AXlink connector.

FIG. 20 Installation Method A

Two #6 nylon screw anchors and two #6 x 1-inch long screws are provided with each

unit.

FIG. 21 Installation method B

1 2 ... 14 15 16 17 18 19 20 21 22

Pas de commentaire

Amx Sensors and Receivers IR Manuel d'utilisateur Page 19