AMX NXV-300 Spécifications télécharger pdf (Page 70)

NetLinx Programming

NXV-300 Modero Virtual Touch Panel

Dynamic Image Commands (Cont.)

^RMF Modify an existing resource.

Syntax:

"'^RMF-<resource name>,<data>'"

Variable:

resource name = 1 - 50 ASCII characters

data = Refer to the table in the RAF command for more information.

Example:

SEND_COMMAND Panel,"'^RMF-Sports_Image,%ALab_Test/Images%Ftest.jpg'"

Changes the resource ’Sports_Image’ file name to ’test.jpg’ and the path to ’Lab_Test/Images’.

^RSR Change the refresh rate for a given resource.

Syntax:

"'^RSR-<resource name>,<refresh rate>'"

Variable:

resource name = 1 - 50 ASCII characters.

refresh rate = Measured in seconds.

Example:

SEND_COMMAND Panel,"'^RSR-Sports_Image,5'"

Sets the refresh rate to 5 seconds for the given resource (’Sports_Image’).

^RAF Add new resources. Adds any and all resource parameters by sending embedded codes and data.

Syntax:

"'^RAF-<resource name>,<data>'"

Variable:

resource name = 1 - 50 ASCII characters.

data = Refers to the embedded codes, see table below.

Example:

SEND_COMMAND Panel,"'^RAF-New Image,%P0%HAMX.COM%ALab/

Test_file%Ftest.jpg'"

Adds a new resource. The resource name is ’New Image’, %P (protocol) is an HTTP, %H (host

name) is AMX.COM, %A (file path) is Lab/Test file, and %F (file name) is test.jpg.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 79 80

Pas de commentaire

AMX NXV-300 Spécifications Page 70