AMX HPX-1600 Manuel d'installation télécharger pdf (Page 37)

HPX-PA-HVI High Voltage Isolator

HPX-1600 Retractable Connection Port

Step 4 - Mark and Trim High Voltage Isolator

Position the High Voltage Isolator so that the partition created by the top folded tabs falls between the last

low-voltage, secondary-circuit module and the first AC Mains Power Outlet.

2. Mark the High Voltage Isolator at the point it exits the aluminum chassis.

3. Remove the High Voltage Isolator and trim the paper so that it will be flush with the bottom of the chassis

upon final installation.

As an additional reference, use the template provided in FIG. 32 to trim the High Voltage Isolator to the proper

length based on the number and type of AC Mains Power Modules installed.

Step 5 - Install AC Mains Power Outlets

Reinstall the trimmed High Voltage Isolator, trapping the low-voltage, secondary-circuit cables on the sides of

the unit as before. Install the AC Mains Power Outlets, Circuit Breaker Modules and Blank Panel Modules

(Including Product Label Panels) as required.

Continue with the HPX-1600 installation as described in the accompanying Installation Guide.

FIG. 32 High Voltage Isolator - Trim Template

The template assumes that no Stop-Block (HPX-AC-SB) is used. The template is for

reference only. Verify that the High Voltage Insulation paper is flush with the bottom of

the aluminum chassis upon final assembly.

1 2 ... 32 33 34 35 36 37 38

Pas de commentaire

AMX HPX-1600 Manuel d'installation Page 37