AMX AXD-CP4/PB Spécifications télécharger pdf (Page 131)

100

101

Installation Ver. 0002 IN - 17

IN.3.3 GROUND CONNECTION

The ground connections of the drives (screwed-on plates) must go to a single point and from

there to the ground terminal of the electrical cabinet. When applying a 10A current between

this ground point and any of these points, the voltage drop must not exceed 1 Volt.

When not having a separate ground point, join the plates to the terminal of the Power Supply

module which, in turn, will be connected to Mains Ground.

CE directive.

In order to ensure compliance with the European Directive on

Electromagnetic Compatibility 89/336/CE, It is a must to:

- power the system through mains filter EMK

- secure the Filter onto a metallic support with a good contact on its whole

base, good ground connection and as close to the Power Supply as

possible.

- Make all the Ground connections indicated on the next figure with a

cable having a section equal to or greater than the three-phase power

supply and at least 6 mm

- always use shielded cables for three-phase motor connections.

1 2 ... 126 127 128 129 130 131 132 133 134 135 136 ... 363 364

Commentaires sur ces manuels

Pas de commentaire

AMX AXD-CP4/PB Spécifications Page 131

Commentaires sur ces manuels