AMX Modero NXD-700Vi Informations techniques télécharger pdf (Page 35)

Installation

7" Modero Widescreen Touch Panels

Installation

NXD-700Vi panels are installed into either a pre-wall surface (using a CB-TP7 conduit/wallbox) or a

solid surface (using either solid surface or drywall screws).

Installing the No-Button Trim Ring

The NXD-700Vi panel is shipped from AMX with the default Button Trim Ring already installed. The

unit is also shipped with an included Trim Ring containing no button openings (a No-Button Trim Ring)

that allows you, if desired, to change the default configuration of the NXD panel Faceplate to that with

no-button openings. In order to install this included No-Button Trim Ring, you must first remove the

factory-installed default Button Trim Ring, the six small buttons, and associated two clear light pipes.

1. The Faceplate is secured to the panel with plastic latches. To remove the Faceplate, simply pull it

away from the panel by gently tugging it outwards until the entire Faceplate comes away from the

panel.

2. Turn the Faceplate over to expose the inside surface and view the Trim Ring latches (FIG. 7).

3. In a single motion, press down and then outwards on the three Trim Ring latches located along the

top of the internal surface of the Faceplate to begin removing the Button Trim Ring. Removing the

Internal Faceplate from the panel exposes the pushbuttons and light pipes along the inside of the

Internal Faceplate.

4. Gently tug along the edges of the Button Trim Ring and work your way around the edges to remove

it from the Faceplate (FIG. 7).

It is recommended that if you are planning on upgrading your flash memory, you do

so before beginning any panel installations.

FIG. 7 Removing the default Button Trim Ring

Default Button Trim Ring

Tr im

(with button openings)

Faceplate

NXD-700Vi Panel/enclosure

Ring

Latches

Button latch

Light Pipe latch

(black)

Button and Light Pipe removal

(showing the internal surface of Faceplate)

(outside surface shown)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 231 232

Pas de commentaire

AMX Modero NXD-700Vi Informations techniques Page 35