Amx MAX-CSE Manuel d'utilisateur télécharger pdf (Page 79)

Displaying Stream Content

MAX-CSE/MAX-CSD10 Operation/Reference Guide

that the unit is detecting an incoming signal (shown by the word SYNC appearing in the

Video Sync section of the UI).

 The most common error found is when a bad cable is not detected and therefore no signal is

available for the unit to encode. The encoding process can continue on a MAX-CSE even

without an actual signal being detected.

9. To complete the setup when using an RTP Transport Protocol on the MAX-CSE, repeat steps 5 and

6 to open another instance of the same application.

10. Within the Port field of the Network tab (in the second player window - B in FIG. 49), enter the

value used with in the Target Audio Port field in the MAX’s Encoder Profiles page. This value can

not match the value used for the previously entered Target Port.

FIG. 49 VLC Player Adjustments (using a sample RTP stream to display each component separately)

RTP Video Stream Component RTP Audio Stream Component

1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 109 110

Pas de commentaire

Amx MAX-CSE Manuel d'utilisateur Page 79