Amx MAX-CSE Manuel d'utilisateur télécharger pdf (Page 17)

MAX-CSE and MAX-CSD10 Installation

MAX-CSE/MAX-CSD10 Operation/Reference Guide

PoE - Special wiring instructions

Before beginning the connection from the PoE switch to the target MAX unit, follow these instructions

carefully:

 Refer to the procedures outlined within the previous Preparing captive wires section on

page 10.

 Install a single wire into the (-) GND side of the rear green 2-pin mini-Phoenix connector

(FIG. 4).

 Connect this wire to a grounded source (FIG. 4). This GND wire provides the necessary ESD

protection to the unit. Only after this step has been completed can you continue on to the

wiring of the PoE connection.

 Pre-configure the 802.3af-compliant PoE switch (such as the NXA-ENET24 PoE) and prepare

it for power transmission to the target MAX unit. Refer to the PoE’s product documentation

for more details.

 Connect a CAT5/CAT6 Ethernet cable from the RJ-45 PoE connector on the PoE switch to the

rear RJ-45 (Ethernet) connector on the target MAX unit (FIG. 4).

When using PoE, you must FIRST ground the unit to provide ESD protection.

The length of the GND wire should not exceed 6 feet (1.83 meters).

FIG. 4 ESD grounding and PoE connection of a MAX unit

PWR +

GND -

Grounded Metal

plate or object

MAX-CSE

802.3af-compliant

PoE switch

EthernetPWR

MAX-

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 109 110

Pas de commentaire

Amx MAX-CSE Manuel d'utilisateur Page 17