AMX Switch Module RDM-SWM Manuel d'utilisateur télécharger pdf

Installation Sheet

RDM-SWM Switch Module 2400 W

The RDM-SWM Switch Module is a 2400 W general purpose relay module

built for economical switching of incandescent lamps, low-voltage

transformers, switched fans and electrical outlets. It is designed for use with

the RDA series of enclosures, in an AMX Lighting™ modular digital

dimming system. The RDM-SWM uses a positive air gap type relay. This

module's 120, 240, and 277 VAC ratings are CE, UL, and C-UL approved.

RDM-SWM UL and C-UL Ratings

• General purpose: 2400 W

• Resistive: 2400 W

• Ballast: 2400 W

• Motor: 277 VAC, 1 hp

Suggested Switched Loads

• Incandescent

• Low-voltage

• Motors

• Switched outlets

• Fluorescent

Specifications

• Dimensions (HW): 10.00" x 2.75" (25.40 cm x 6.99 cm)

• Non-phase dependant

• Use wires rated at 75°C (167°F)

• Torque terminals to 7 in-lbs. (0.8 N/M)

• Max. wire size: 10 AWG (4 mm²)

• Wire stripping length: 0.28" (7 mm)

• Weight: 0.5 lbs. (0.227 kg)

• BTU/hr: 5

• Control current: 85 mA @ 12 VDC

Caution: Pre-Installation Notes

• All Class 1 wiring must be connected to proper terminals.

• All control wiring must be connected to proper terminals.

• Disconnect power while installing or connecting the unit.

• Keep top and bottom air vents clear at all times.

• Test loads for shorts before connecting.

• Use low-voltage wires with a 300 volt rating or greater.

• Use field installed copper conductors.

• All electrical ratings are for continuous duty.

• For indoor use only.

• This module may require extra power from the AXlink connection or an

external power supply connected to the control card.

Connecting the RDM-SWM to the AMX Lighting Master

FIG. 1 RDM-SWM Switch Module

Relay A

Line in (hot)

Load out

Mounting

points

Low-voltage control wiring:

4-pin connector to AMX

Lighting master controller

High-voltage

connections

FIG. 2 RDM-SWM connections

Pin 4 (GND)

Pin 3 (RLY)

Pin 2 (DIM)

Pin 1 (+12 V)

3 (-)

1 (+)

RDM-SWM 4-pin module connector

4-pin plug from RDM series module

NOTE: The 4-pin plugs from the module connector to

the 4-pin connector on the master (black plug cover facing up).

1 2

RDM-SWM Switch Module 2400 W 1

Résumé du contenu

Page 1 - RDM-SWM Switch Module 2400 W

Installation SheetRDM-SWM Switch Module 2400 WThe RDM-SWM Switch Module is a 2400 W general purpose relay module built for economical switching of inc

Page 2

AMX Corporation reserves the right to alter specifications without notice at any time. For full warranty information, refer to the AMX Instruction Man