
Appendix A: Installing SQL Server 2008 Express Edition
97
RMS Enterprise - Installation Guide
Appendix A: Installing SQL Server 2008
Express Edition
Overview
The instructions in this Appendix are intended to assist in installing and configuring SQL Server 2008 Express
Edition for use with RMS Enterprise.
While RMS does support Microsoft SQL Express 2008 databases, the RMS services and website
must connect using a TCP/IP connection or named pipes.
Connecting to SQL Express 2008 via shared memory is not supported.
The Network Administrator should perform this type of configuration.
Installing SQL Server Express
The steps below describe installing SQL Server Express for RMS Enterprise via the SQL Server 2008 Setup
installation routine.
The following section (Configuring SQL Express via the SQL Server Configuration Manager on page 101)
describes configuring SQL Server Express for use with RMS Enterprise.
1. Download the SQL Server 2008 Express Edition (SP1 or higher) installation file from Microsoft.
2. Run the downloaded file to launch the SQL Server Installation Center.
3. Click on Installation in the menu pane to open the page shown in FIG. 129:
4. Click on New SQL Server stand-alone installation or add features to an existing installation to
proceed to the Product Key page.
5. Since SQL Express does not require a Product Key, click Next to proceed to the Setup Support Rules
page.
SQL "Express" is only appropriate for systems with less than 50 locations. See the
Supported Database Platforms section on page 8 for details.
You can use the SQL Server Configuration Manager utility to configure (or change
the current configuration of) the SQL Server after it has been installed.
FIG. 129 SQL Server Installation Center
Commentaires sur ces manuels