AMX Rack Rail Kit MMS Servers Guide d'installation télécharger pdf (Page 23)

Connecting the Media Server Cables

Connecting to a 2-Gb MEDIASwitch

Use the following procedure to correctly connect an optical SFP and

optical cable to a 2-Gb MEDIASwitch.

To connect an optical cable to the 2-Gb MEDIASwitch:

1. Locate the optical SFP in the Media Server kit.

2. Route the optical cable from the Media Server to the MEDIASwitch, if

it has not been installed already.

3. Position the optical SFP in front of a MEDIASwitch port (see

Figure 4). Make sure the optical cable connector is facing away from

the MEDIASwitch.

Figure 4 Installing an SFP Connector

You can install the SFP while the MEDIASwitch is turned on.

4. Slide the optical SFP into the MEDIASwitch port. You should hear a

click when the optical SFP is seated in the port.

5. Remove the protective covers from the optical cable connector on the

optical cable.

6. Remove the protective cover from the optical SFP in the

MEDIASwitch.

100

Act/Col

0550201A_BK.book Page 23 Thursday, January 9, 2003 10:44 AM

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 57 58

Pas de commentaire

AMX Rack Rail Kit MMS Servers Guide d'installation Page 23