AMX Network Device TX-CTB Manuel d'utilisateur télécharger pdf (Page 6)

NI Wireless Sensor Network Devices 6 ni.com

Step 3. Install NI-WSN Software on the NI-9792

If using a NI 9792, complete the following steps to install NI-WSN

software on the NI 9792 WSN Real-Time Gateway:

1. Launch MAX.

2. Expand Remote Systems to confirm that MAX detects the

NI 9792. If MAX is not detecting your device, refer to step 2

of Step 4. Configure the NI WSN System.

3. Click on Software and select Add/Remove.

4. Install NI-WSN for LabVIEW software.

Step 4. Configure the NI WSN System

You must configure the NI WSN devices in MAX before using

NI LabVIEW to take measurements. For information about

configuring the WSN system, refer to Start»Programs»National

Instruments»NI-WSN»Configuring WSN in MAX. To confirm

device recognition and configure the NI WSN system, complete

the following steps:

1. Launch MAX.

1 2 3 4 5 6 7 8 9 10 11 12 13 14

Pas de commentaire

AMX Network Device TX-CTB Manuel d'utilisateur Page 6