Amx TPI-PRO-2 Manuel d'utilisateur télécharger pdf (Page 103)

Programming

TPI-PRO Total Presentation Interface - Pro Edition

^BRD

Set the border of

a button state/

states.

This command works only if the specified border is not the same as the current border.

The border names are available through the TPDesign4 border-name drop-down list.

Syntax:

"'^BRD-<vt addr range>,<button states range>,<border name>'"

Variable:

variable text address range = 1 - 4000.

button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons

1 = Off state and 2 = On state).

border name = Refer to the Border styles table on page 84.

Example:

SEND_COMMAND Panel,"'^BRD-500.504&510.515,1&2,Quad Line'"

Sets the border by name (Quad Line) to those buttons with the variable text range of

500-504 & 510-515.

Refer to the TPD4 Border Styles by Name table on page 84.

^BSF

Set the focus to

the text area.

Note: Select one button at a time (single variable text address). Do not assign a variable

text address range to set focus to multiple buttons. Only one variable text address can be

in focus at a time.

Syntax:

"'^BSF-<vt addr>,<selection value>'"

Variable:

variable text address = 1 - 4000.

selection value = unselect = 0 and select = 1.

Example:

SEND_COMMAND Panel,"'^BSF-500,1'"

Sets the focus to the text area of the button.

^BSM

Submit text for

text area buttons.

This command causes the text areas to send their text as strings to the NetLinx Master.

Syntax:

"'^BSM-<vt addr range>'"

Variable:

variable text address range = 1 - 4000.

Example:

SEND_COMMAND Panel,"'^BSM-500'"

Submits the text of the text area button.

^BSO

Set the sound

played when a

button is pressed.

If the sound name is blank the sound is then cleared. If the sound name is not matched,

the button sound is not changed.

Syntax:

"'^BSO-<vt addr range>,<button states range>,<sound name>'"

Variable:

variable text address range = 1 - 4000.

button states range = 1 - 256 for multi-state buttons (0 = All states, for General buttons

1 = Off state and 2 = On state).

sound name = (blank - sound cleared, not matched - button sound not changed).

Example:

SEND_COMMAND Panel,"'^BSO-500,1&2,music.wav'"

Assigns the sound 'music.wav' to the button Off/On states.

"^" Button Commands (Cont.)

1 2 ... 98 99 100 101 102 103 104 105 106 107 108 ... 147 148

Commentaires sur ces manuels

Pas de commentaire

Amx TPI-PRO-2 Manuel d'utilisateur Page 103

Commentaires sur ces manuels

Produits connexes et manuels pour Matériel Amx TPI-PRO-2