AMX DESIGN XPRESS V 1.5 - ON SITE INSTALLER GUIDE Guide d'installation télécharger pdf (Page 34)

TIBCO ActiveMatrix BPM Installation and Configuration

Chapter 2 Pre-install Considerations

Using Third Party Solution

Figure below illustrates the use of third-party solutions to provide highly

available, fault tolerant capabilities to your BPM runtime.

The setup requires at least three machines, say M1, M2, and M3, where:

• TIBCO ActiveMatrix BPM (or at least the data folder) is on the shared file

system which is only available to the machine that has a fully operational

TIBCO ActiveMatrix BPM node installed and running.

• TIBCO ActiveMatrix BPM and TIBCO ActiveMatrix Administrator are

installed and running on one machine (M1).

• The other machines (M2 and M3) are:

— connected to a shared file system

— a part of an active-passive clustering setup. At any given time, one of the

machines will have access to the shared file system on which the TIBCO

ActiveMatrix BPM Node is installed/running.

In case of any catastrophic event such as power loss, hardware failure,

network disruption, or operating system crash, the cluster software detects

it and fails over to the next available server.

— One of these two machines should have a fully operational TIBCO

ActiveMatrix BPM node installed and running.

See Using A Third-Party Solution on page 54 for details on implementing this

scenario.

1 2 ... 29 30 31 32 33 34 35 36 37 38 39 ... 224 225

Pas de commentaire

AMX DESIGN XPRESS V 1.5 - ON SITE INSTALLER GUIDE Guide d'installation Page 34