AMX UPC20+ Spécifications télécharger pdf (Page 9)

Product Information

UPC20+ Universal Power Controller

Specifications

UPC20+ Specifications

Power Self-powered when used with 110/220 VAC

Power input (for control board) 120/240V

, 50-60 Hz, 0.05/0.025A

-or-

12 VDC, 0.2A max

Power output per relay • 20A @ 120/240V

, 50-60 Hz (RESISTIVE LOAD)

• 6A @ 277V

, 50-60 Hz (FLUORESCENT BALLAST)

• 1 HP @ 120V

, 50-60 Hz (INDUCTIVE LOAD)

• 2 HP @ 240V

, 50-60 Hz (INDUCTIVE LOAD)

Total Current through both relays CAN NOT exceed 20 amp.

Maximum operating ambient

temperature

55°C

Approvals UL / C-UL / CE

Includes • 1-, 2-, and 3-button logic modes

• Local test switches with status LEDs

• 120, 240, and 277 VAC control capability

Inputs • 4 closure inputs, operation defined by mode.

• One IR remote sensor input.

• Motor Control mode alternates between the timed operation of the two

power relays.

• Power Control mode allows independent control of both power relays.

Control Ports Two 2400 W power relays. Total combined current through both relays is 20

Amps.

Input Power Switch (S1) • Set this switch according to the high voltage wiring that will be connected

to terminals 5 and 6 on P1. Refer to theP1 Terminal Connections section

on page 7.

• Set switch S1 to the line input voltage value used before applying power to

the UPC20+.

High Voltage Terminal Block (P1) High voltage input and output wiring for motor or power control.

Low voltage and Control

Terminal Block (P2)

Contact closure, open-collector or CMOS logic level remote control wiring.

Inputs 5 - 8 are referenced to the common connection at pin 4.

Jumper JP1 Sets control mode of the unit to contact closure or remote sensor serial

data.

Test Switches (PB1 and PB2) Provides local operation of relays K1 and K2 for testing power circuits or

motors connected to the relay terminals. An LED indicates relay power

applied.

Motor Time Delay Potentiometer

(R8)

Only used in motor control modes. User adjusted for setting relay release

time between 0 and 90 seconds.

DIP Switch (S2) Provides selection of control mode options. See Motor Control Mode DIP

Switch S2 Positions table on page 4 and Control Input Wiring to Connector

P2 Terminals table on page 4 for control mode settings.

Enclosure Metal with black matte finish, knockouts for conduit.

Dimension (HWD) • 8.5" (10.5" including flange) x 4.5" x 2.2"

• (220 mm (270 including flange) x 110 mm x 60 mm)

Weight 3.0 lbs. (1.4 kg) with flange

Options 12 VDC power supply (for 277 VAC applications)

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 20 21

Commentaires sur ces manuels

Pas de commentaire

AMX UPC20+ Spécifications Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Contrôleurs de puissance à distance AMX UPC20+