AMX RE-DM6 Spécifications télécharger pdf (Page 60)

Appendix A: AMX Lighting Curves

RE-DM4 and RE-DM6 RADIA Eclipse Dimmer Modules

The following table provides a general relationship between load type and which curve to use:

Standard Dimming Curve (1)

FIG. 39 shows the curve 1 voltage output in 120 volts DC.

Load Type Curves

Incandescent Curve 1 – Standard dimming curve

Curve 2 – Energy efficient, uses 10% less energy.

Advance Mark VII Ballast Curves 3, 5, or 6

4-wire Ballasts Curve 5 – Used for some ballasts

Curve 7 – Used with other ballasts with the RDM-DC series of modules.

Low voltage Curves 5, 6, B, C – All logarithmic curves with slight variations in the curve.

Lutron FDB Ballasts Curve 8 – Used in conjunction with the RDM-FDB series of modules.

Curve 9 – Used in conjunction with the RDM-FDB series of modules.

Provides a slightly different “look” than curve 8. Since this curve has the

highest low end turn-on level by default, it is probably a good choice for

Advance Mark X. We have found the Mark X usually needs its low-end set-

ting adjusted higher.

Non-dimming/Switched Curve N, Curve E – Used for ON/OFF control only. Useful for all switch

modules (i.e. RDM-SWM, RDM-HSW, RDM-DPSM, RDM-ZC modules).

Fan motors Curve R - Used for devices that start at a high voltage and then decrease

voltage in order to function.

FIG. 39 Curve 1 Voltage output in 120 Volts AC

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 89 90

Pas de commentaire

AMX RE-DM6 Spécifications Page 60