AMX FG1311-16-KW Spécifications télécharger pdf (Page 31)

Novara AxLink KeyPads

Novara ControlPads & KeyPads

Alternate Button Numbering: 16-Button KeyPads

The DIP Switch settings for 16-button KeyPads are described in FIG. 13:

Setting the AxLink Address DIP Switch

The AxLink Device Address DIP switch determines whether this KeyPad will function as an AxLink device

or as a Serial device.

If the DIP Switch is set to anything other than zero, this KeyPad will be assigned an AxLink device address

based on the switch settings.

Setting the AxLink Device Address

If connected, disconnect the power supply.

2. Locate the 8-position Device DIP switch on the rear panel.(FIG. 14).

3. Set the DIP switch according to the switch values shown below.

The device number is set by the total value of DIP switch positions that are ON (up). As an example, the

first DIP switch in FIG. 14 defines device number 129 (1+128=129).

If you later change the device number, remove and reconnect the AxLink power connector to enter the new

device number into memory. Use AMX’s Dip Switch2 application (available for download from

www.amx.com) to assist in calculating Dip switch position values.

Programming AxLink Keypads

The SP-08-AX and SP-AX-16 AxLink Keypads can be controlled via Serial commands (see the Novara

RS232 Codes section on page 79), but are typically programmed using the standard NetLinx keypad device

format (like any other keypad).

These keypads issue a Push, and feedback is controlled by turning the channel on and off.

When using it as a standard NetLinx device there is no special or device specific programming to

deal with.

The SP-08-AX and SP-AX-16 Axlink Keypads are programmed using the standard Netlinx keypad

device format.

FIG. 13 DIP Switch Settings - Alternate Button Numbering: 16-Button KeyPads

Switch 12345678

Value 1 2 4 8 16 32 64 128

FIG. 14

Example Device DIP Switches

1-16

17-32

Switch 1-down / Switch 2-down = Buttons 1-16

Switch 1-down / Switch 2-up = Buttons 17-32

781234 56

781234

Device Address = 129 Device Address = 0 (XPort)

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 87 88

Pas de commentaire

AMX FG1311-16-KW Spécifications Page 31