Amx Mio Modero Device Family Manuel d'utilisateur télécharger pdf (Page 11)

Installation

Mio Modero Device Family

Mio Modero Prestige

The Mio Modero Prestige ships with sheets of common menu items and icons for creating inserts for single

and double buttons.

1. If connected, disconnect the power supply.

2. If connected to mounting frame, place a flathead screwdriver in the notch at the bottom right of the Mio

Modero, and pry the faceplate from the mounting frame.

3. On the back of the faceplate locate the button access points, outlined with white circles.

Using a straightened paperclip, poke through the button access points until the buttons pop free.

4. The Prestige buttons are comprised of three parts, the frame, window, and back insert. From the front of

the button, use your thumb to poke the window and back insert out of the frame. See FIG. 4.

5. Snap the widow into the frame and then place the printed labels inside each button.

6. Snap the back inset to the window and frame.

7. Insert the buttons into their proper location on the faceplate.

8. If the power supply was disconnected in Step 1, reconnect and return power to the device.

9. Snap the faceplate on the mounting frame.

Setting The AxLink Device Number

1. If connected, disconnect the power supply.

2. Locate the 8-position Device DIP switch on the rear panel.(FIG. 5).

3. Set the DIP switch according to the switch values shown below.

The device number is set by the total value of DIP switch positions that are ON (up).

As an example, the DIP switch in FIG. 5 defines device number 129 (1+128=129).

FIG. 4 Prestige Button Components

Switch 12345678

Value 1 2 4 8 16 32 64 128

FIG. 5

Example Device DIP Switch set to 129

Frame

Window

Printed Label

Back Insert

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 27 28

Pas de commentaire

Amx Mio Modero Device Family Manuel d'utilisateur Page 11