Amx Modero NXD-500i Manuel d'utilisateur télécharger pdf (Page 67)

Setup Pages and Descriptions

NXD-500i 5" Wall/Flush Mount Touch Panel with Intercom

Calibration Page

The Calibration page (FIG. 46) allows you to calibrate the touch panel for maximum sensitivity.

 Press and hold the Front Setup Access button for 6 seconds to access the Calibration page.

 Press the crosshairs to calibrate the panel and return to the last active firmware page.

FIG. 46

Calibration page (actually 3 separate screens)

The request to touch the crosshairs

is the first on-screen message

Calibration successful is the second

on-screen message that appears

On-screen crosshairs used for

calibration of the touch device

after the calibration process is

completed

If the calibration was improperly set and the Calibration page cannot be

reached through the panel’s firmware, this firmware page may be accessed via

G4 Web Control. Navigate to the Protected Setup page and press the Calibrate

button through the VNC window. This action causes the panel to go to the Calibration

page seen above, where the touch panel may be physically recalibrated again using

the above procedures.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 147 148

Pas de commentaire

Amx Modero NXD-500i Manuel d'utilisateur Page 67