Amx NetLinx Custom Panel Interface NXP-CPI16 Manuel d'utilisateur

Operation/Reference GuideCustom Panel InterfacesNXP-CPI16NetLinx Custom Panel InterfaceLast Revised: 1/13/2009

Send_CommandsUse the Send_Commands listed in the table below to program the NXP-CPI16.Send_CommandsBMODEConfigures either set of 8 outputs as an 8-seg

7NXP-CPI16 NetLinx Custom Panel InterfaceSend_Commands (Cont.)LV L _S ZSets the size (data type) of the value that will be used by the NXP-CPI16 when

8NXP-CPI16 NetLinx Custom Panel InterfaceThe NXP-CPI16 uses input channels to report user input on the contacts or switches attached to the input term

9NXP-CPI16 NetLinx Custom Panel InterfaceEach of the two 20-pin connectors is assigned a group of 8 input and output channels. The table below shows t

10NXP-CPI16 NetLinx Custom Panel Interface

System Worksheets11NXP-CPI16 NetLinx Custom Panel InterfaceSystem WorksheetsHeader 1Header 2Dealer ID DateDealer PO NumberJob SO NumberDescription Ser

CH9CH10CH11CH12CH13CH14CH15CH16OutInOutInOutInOutInOutInOutInOutInOutIn9101112GroundPowerGroundGround113214315416517618719820

1/09 ©2009 AMX. All rights reserved. AMX and the AMX logo are registered trademarks of AMX. AMX reserves the right to alter specifications without n

AMX Limited Warranty and DisclaimerAMX warrants its products to be free of defects in material and workmanship under normal use for three (3) years fr

Table of ContentsiNXP-CPI16 NetLinx Custom Panel InterfaceTable of ContentsProduct Information ...

Product Information1NXP-CPI16 NetLinx Custom Panel InterfaceProduct InformationThe AMX NXP-CPI16 is a NetLinx panel device that allows system integrat

2NXP-CPI16 NetLinx Custom Panel InterfaceSpecificationsThe table below lists the NXP-CPI16 specifications.NXP-CPI16 SpecificationsPower Requirement 12

3NXP-CPI16 NetLinx Custom Panel InterfaceInput and Output ConnectorsTo install the NXP-CPI16, connect ribbon cables or a PC board to one or more of th

4NXP-CPI16 NetLinx Custom Panel InterfaceQuadrature InputsBy default, the quadrature inputs expect the phase relationship, shown in FIG. 2, for a cloc

Programming5NXP-CPI16 NetLinx Custom Panel InterfaceProgrammingThere are two modes of Channel Assignments: Discrete Output and Default Mode. Both mode